Assembly Instructions for Cranky LEGO Set

Connect the 4-by-4 brick to the top of the tapering tower brick. Both bricks are gray and have green struts and beams painted on the sides. Match up the struts and beams of the tapering tower brick to the 4-by-4 brick.

Connect a pair of 2-by-4 green plates on top of the gray brick in line with each other.

Connect another 4-by-4 brick on top of the green plates.

Connect another pair of 2-by-4 green plates on top of the gray brick.

Connect the special brick, part number 4279607, to the top of the gray brick. The special brick is gray and looks like holder for a rotating assembly.

Connect the rotating yellow plate to the green holding assembly brick. The holding assembly brick is part number 4279611. Connecting these two together creates a spinning yellow plate in a green housing. Insert the green housing into the gray specialty brick.

Connect two 2-by-2 gray bricks to a 4-by-8 green brick.

Connect two 1-by-4 green bricks to the long side of the 4-by-8 green brick. These extend at right angles from the gray bricks. Connect the special Cranky face brick, part number 4279608, at a right angle to the two side bricks. Sandwich these bricks with another 4-by-8 green brick.

Connect the black Cranky brick to the top of the large green brick. Connect the long gray strut brick to the top of the green brick so it hangs over the front side, on top of the Cranky face brick.

Connect the pre-assembled pulley system brick to the end of the gray strut brick. Connect this whole assembly to the top of the rotating tower to complete your Cranky tower.