Hot Wheels V Drop Instructions

Grasp the door mounting bracket on each end. Pull the ends straight out until the three sections click into place. Snap the stabilizers into place on each side of joints of the bracket to keep it straight.

Push the track bracket onto the underside of the door hanger bracket until it snaps into place. Push the door hanger bracket onto the top of the door mounting bracket until it snaps into place.

Snap the smaller car release bracket into place on the top of the door hanger bracket.

Slide a length of track onto the track bracket. The end of the track must be flush with the end of the bracket. Snap the car holder into place on the elevator bracket. The elevator bracket is on the center section of the door mounting bracket.

Open the door. Place the clamp on the top of the door mounting bracket over the top of the door. Let the lower end of the bracket rest against the vertical surface of the door. Close the door.

Insert a track connector into the slot at the bottom of the piece of track installed on the door mounting bracket. Insert another piece of track into the opposite end of the connector until the pieces are flush with each other. Add as many extra track pieces as you want. Grasp the end of the assembled track and gently pull it away from the door.

Snap the ramp end bracket on the top of the car ramp. Slide the last piece of track installed on the door into the car ramp until the end of the track is flush with the end of the ramp.

Pull the car ramp as far away from the door as the track will allow. Place a Hot Wheels car into the car holder on the elevator. Rotate the hand wheel beside the elevator bracket downward to raise the car to the top of the door. Continue raising the car until it releases itself from the elevator and rolls down the track.