How to Use an Air Hog Gyrocopter

Charging Your Air Hog Gyrocopter

• 1

  Remove the battery cover on controller using a Phillips screwdriver. Install 6 AA batteries and replace the battery cover.

• 2

  Push the Gyrocopter's On/Off switch to "Off".

• 3

  Set the controller's On/Off/Charge switch to "Off".

• 4

  Lift the controller charge door and remove the charging cord.

• 5

  Insert the charge cord into the receptacle on the bottom of the Gyrocopter.

• 6

  Push the controller's On/Off/Charge switch to "Charge." The LED light will illuminate green. Charging is complete when the light goes out.

• 7

  Remove the charging cord from the underside of the Gyrocopter and replace it in the controller.

Flying Your Air Hog Gyrocopter

• 8

  Extend the controller antenna fully.

• 9

  Set the controller On/Off/Charge switch to "On." The power LED light will illuminate red.

• 10

  Push the Gyrocraft's On/Off switch to "On."

• 11

  Hold the Gyrocraft by the underside and wave it in an up-and-down motion 5-10 times to start rotation of the rotors.

• 12

  Toss the Gyrocraft gently into the air in a forward motion aiming into the wind. Ease up on the throttle and allow the Gyrocraft to stabilize before attempting to steer.

• 13

  Push throttle stick forward to increase altitude. Push the steering stick right or left to turn the Gyrocraft.