Hobbies And Interests
Things You'll Need
Instructions
Nano Hawk
Turn off the controller. Unscrew the battery cover on the back of the charger and remove the cover. Install four fresh AA batteries in the battery compartment. Replace the cover and the screw.
Turn off the charger and the plane. Plug the plane into the charger dock. Set the switch on the charger to the "CHG" position. Wait until the green LED on the charger turns off, then set the switch to the "Off" position. Disconnect the plane.
Inspect the plane's rear rudder. If it is damaged, pull it straight out of the back of the plane and push the replacement rudder in.
Turn the plane's power switch to the "On" position, then turn on the charger's power switch.
Push the left throttle stick all the way forward while keeping the right steering stick centered. Lightly toss the plane forward to launch it. Adjust the left throttle stick so that the plane rises slowly.
Press the right trim button to correct the plane if it veers to the left. Press the left trim button if the plane veers to the right. Press the button as many times as necessary to make the plane fly straight.
Fly the plane in an environment without bright lights to avoid interference. Remain within 16 feet of the plane to avoid signal loss.
Zero Gravity Nano
Turn off the controller. Unscrew the battery cover on the back of the charger and remove the cover. Install six fresh AA batteries in the battery compartment. Replace the cover and the screw.
Turn off the charger and the car. Place the car on the charger dock and slide the car onto the charging plug. Set the switch on the charger to the "Charge" position. Wait for the red and green LED lights to start blinking on the charger, then set the switch to the "Off" position. Disconnect the car.
Slide the switch on the back of the car to the "G" position. Slide the switch on the controller to the "On" position. Place the car on the ground.
Press the forward button on the left side of the controller to drive the vehicle forward. If the vehicle pulls to the left, press the "R" button on the front face of the controller. If the vehicle pulls to the right, press the "L" button. Press the button as many times as necessary until the car drives in a straight line.
Lift the car off the ground and position the air skirts on the bottom of the vehicle to a 45 degree angle. Clean the vehicle's wheels.
Turn the switch to the "W" position and place the vehicle on a smooth and clean wall or ceiling. Use the forward and reverse buttons and the steering wheel to drive the car.
Remove the car from the wall when the car's headlights begin blinking. Turn the car off and place it back on the charger.