Instructions
Power off the helicopter and remote control and charge the helicopter using the charge wire hidden inside the center compartment. Plug it in and switch the charger on. Charge until the LED on the controller goes out. Then remove the cord and return it to the compartment.
Power on the controller and helicopter again, and ease the throttle up to lift the helicopter off the ground. Try to get it into a straight hover.
Adjust the trim if the helicopter is spinning. If the helicopter is spinning clockwise, adjust the trim to the right. If spinning to the right, adjust the trim to the left.
Try to ease the aircraft forward using the throttle and controls. If you cannot get it to fly forward, bring the helicopter back down by easing the throttle down and letting the copter land.
Add the adhesive weights included with the helicopter and take off again. Add one at a time and keep retesting the aircraft until it successfully starts flying forward as you want it to.