Home >> Toys >> Toy Vehicles

How to Add Rubber Bands for Traction on Ride-On Toys

Adding rubber bands to the tires of ride-on toys helps add traction. It also helps to protect plastic tires, dampen tire noise, and provide safer steering for the toy. Children will require less help with their toys and will enjoy a new sense of independence when traction bands are added to their favorite ride-on toys.

Things You'll Need

2-3 inch wide Heavy Duty Rubber bands
2-3 ounces of Professional Strength Adhesive
Wire brush or sandpaper
Soap
Water

Instructions

- 1
  Clean all the wheels with soap and water, using the wire brush or sandpaper in the middle where the rubber band will set. Be sure to rinse away all soap, and dry thoroughly.
- 2
  Remove the battery from the ride-on toy if it is equipped with one, and place the vehicle on its side with the wheels facing up.
- 3
  Stretch the rubber band out by placing your fingers inside and creating a stretched oval.
- 4
  Stretch the traction band over the tire by starting at the top of the tire and working the rubber band over the sides and then over the bottom of the tire
- 5
  Center the traction band over the toy's tire. Spin the tire to ensure the band is properly placed in the middle of the tire.
- 6
  Fold the rubber band back or lift the traction band up to put adhesive on. You should use about half an ounce of glue per tire.
- 7
  Wipe away any extra glue that oozes out from under the rubber band with a paper towel or a rag. Make sure to remove the excess glue while the glue is still wet. Allow the glue to dry per manufacturer's directions before allowing the child to ride on the toy.

Toy Vehicles