How Are Hot Wheels Made?

Blueprints

• First Mattel analyzes blueprints from the full-sized car. Then the company's design group sizes-down the car to insure that the vehicle can be produced within its 1/64-inch footprint.

Plastic Mock-Up

• After the sizing process is completed, the designers build a mock-up of the car in plastic. Then Mattel's management looks at the replica, and either agrees to produce the car or scraps the design.

First Die-Cast

• Presuming that the design is validated, the company then builds a secondary mockup, but in this case the model is die-cast using production materials (usually a combination of zinc and aluminum, sometime referred to as "zymak").

Final Acceptance

• Once the die-cast mock-up is ready, Mattel's management again validates the design to insure that the look of the car and the production value is acceptable. If so, this mock up is then used as an initial production template.

Production

• The template mold is replicated and installed on a production jig. Once the molds are in place, an automated system injects zymak in the molds, then subjects them to a cooling process. Then the axles and wheels are added. The cars are then sent to final packaging and out to the stores.