Hobbies And Interests
Instructions
Separate the 31 LEGO pieces included with the remote. These pieces are specially fitted for the Wii remote and feature the connection side with a smooth surface side. All the pieces are rectangular except the square-shaped LEGO logo piece.
Snap the pieces onto the remote by matching them up with the connectors and pushing them into place. Repeat this process until the whole remote is covered or you achieved the desired design.
Use the "LEGO Removal Tool" packaged with the controller. Slip the tool in-between the crack of a piece and gently lift up until the piece is loosened and removed.
Slip the red wrist connector through the attachment on the bottom of the rope. Slip the other end of the wrist strap through the open hole to secure the strap to the controller.
Connect the Wii Classic Controller, Wii Motion Plus or the Wii Nunchuk into the bottom of the controller. The open port is a replica of the regular Wii extension port.
Connect the remote into a Wii accessory like a steering wheel, tennis racket, golf club or gun extension. The remote is slightly wider than regular Wii remotes, but should fit snugly in most accessories. Do not try and force the remote in or it could break the accessory.
Choose a battery cover for the back of the remote. There is a standard yellow battery cover or a LEGO-connector battery cover. Both snap into the back of the remote with a slight click.
Use other LEGOs you own to build a remote stand. Gently press the LEGO-connector battery cover down onto the top of the LEGO stand to hold it in place. Jiggle the remote and lift it off to remove it.
Press "1" and "2" on the remote to start the "sync" process with the Wii. Blue lights will flash until the Wii reads the remote and makes a connection.