Home >> Internet Games >> PlayStation 3

How to Put a Rapid Fire Mod on a Controller With No Resistor

Shooter games are one of the most popular genres in the video gaming industry. This has a lot to do with the teamwork aspect involved in these games and their online capabilities. With so much personal pride at stake, players are looking for advantages to improve their performance. One of the biggest advantages you can gain is adding rapid fire capabilities on your PS3 controller to allow you to shoot rounds much faster.

Things You'll Need

Phillips screwdriver
Intensafire rapid fire mod kit

Instructions

- 1
  Remove the screws on the back of the PS3 controller using a Phillips screwdriver. Three of these screws are located at the top left, center and right. Two of these screws are located on the bottom row on the left and right. Place the screws aside where they will not be lost.
- 2
  Follow the seam of the PS3 controller until you find the clasp at the bottom. Press the center clip down and pull the two sides apart. Set aside the piece of the controller with the buttons. Set the other side down so the electrical components are facing you.
- 3
  Remove the battery by unclipping it. With the battery removed, you can see the motherboard.
- 4
  Plug the wires of the "Intensifire" into the "Player 3" and "Player 4" slots located at the top right of the motherboard. Remove the plastic covering from the "Intensafire Chip" and place the chip on top of the "IC Chip." The IC chip is the chip in the center of the motherboard.
- 5
  Clip the battery where it came from over the "Intensafire Chip," then reunite the two sides of the controller. Use a Phillips screwdriver to tighten the five screws into the back of the controller.

PlayStation 3