How to Disassemble the Saitek X52 Joystick

Unscrew the four medium-size Allen screws at each corner of the hand guard with the appropriate-size Allen key. Look directly down onto the shaft to see one more small screw at the top of the guard. Remove this with a No. 0 Phillips screwdriver and then lift off the hand guard and place it to the side.

Unscrew the three small Phillips screws underneath the stick's hand rest (the protrusion at the lower end of the shaft that your hand sits on during play) with the small screwdriver. Pry the hand rest away from the body of the stick, taking care not to snap the fine wire connecting the switch beneath the hand rest. This wire can't be removed, so leave the switch attached and push it out of the way if you need to get at the body of the stick.

Unscrew the five medium-size screws at the side panel of the stick using the medium (No. 5) Phillips screwdriver. Grasp the stick and push it toward the panel to relieve tension on the springs as you pull the side panel away.

Remove the plastic panel from the rounded knob on the base of the stick to reveal a small screw on the left-hand side. Unscrew this with the No. 0 screwdriver and remove the screw and washer. Pull up on the joystick handle and remove the cover from the base, taking care not to snap any thin wires.

Unscrew the five medium-size screws on the right side of the stick handle using the No. 5 screwdriver, then push the stick down to release spring tension as you pull the right and left sides of the handle away from each other. Remove the handle to complete dissemble the stick.