The PulseVu is a LED light controlling device that is designed to be soldered directly to the motherboard of your Xbox 360 gaming system console. The PulseVU is made to control the LED lighting from your gaming console as well as any external LED lighting connected to it. These lights can be set to pulsate along will music that is played on your Xbox 360 system. Some other light settings that can be set through the PulseVU include fading, dimming and solid "on" modes. The process of installing the PulseVU onto your Xbox 360 gaming system is fairly straightforward.
- Torx screwdriver set
- Soldering tools
Show More
Instructions
-
-
1
Remove the six screws on the outer case of your Xbox 360; lift the outer case off exposing the the bottom of the system's motherboard.
-
2
Solder the PulseVU device directly on the mother board at the "AL," "AR," "+," "-," "PO," "Power SW," "Sync SW" and "Eject SW" points on the Xbox 360 motherboard.
-
-
3
Plug the negative side of the connection cable from your LED panel into the VU pad port on the PulseVU device.
